Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 93

4.
Set the items in "Required Settings" as follows.
[Navigation window]  [Parameter]  [Module Information]  [FX5-CCL-MS]  [Module Parameter]  [Required
Settings]
5.
Set the own station setting as follows.
[Navigation window]  [Parameter]  [Module Information]  [FX5-CCL-MS]  [Module Parameter]  [Basic Settings]
 [Own Station Setting]
6.
Set the link refresh settings as follows.
[Navigation window]  [Parameter]  [Module Information]  [FX5-CCL-MS]  [Module Parameter]  [Basic Settings]
 [Link Refresh Settings]
7.
Set the supplementary cyclic settings as follows.
[Navigation window]  [Parameter]  [Module Information]  [FX5-CCL-MS]  [Module Parameter]  [Application
Settings]  [Supplementary Cyclic Settings]
8.
Write the set parameters to the CPU module on the intelligent device station. Then reset the CPU module or power off
and on the system.
[Online]  [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameter setting,
refer to the chapter explaining the parameters in this manual. ( Page 58 PARAMETER SETTINGS)
8.3 Example of Communications Between a Master Station and a Intelligent Device Station
8 PROGRAMMING
91
8