Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 33

Setting method
Set the mode in "Mode" under "Required Settings." (Page 59 Mode)
Remote net Ver.1 mode
The remote net Ver.1 mode is selected when a system is configured only with the master station and Ver.1-compatible slave
stations.
When the system includes a Ver.2-compatible slave station, select the remote net Ver.2 mode.
Master station
(remote net Ver.1 mode)
Station No.0
Ver.1-compatible
area RX
Station
No.1
Station
No.2
Station
No.3
RY
Range of the master
station sending data to
the station No.1
Range of the master
station sending data to
the station No.2
Range of the master
station sending data to
the station No.3
RWr
Station
No.1
Station
*2
No.2
Station
No.3
RWw
Range of the master
station sending data to
the station No.1
Station
*2
No.2
Range of the master
station sending data to
the station No.3
*1 The last 16 bits in RX, RY cannot be used when using the master/intelligent device module as the intelligent device station.
*2 Although a remote I/O station does not have RWr and RWw, areas in RWr and RWw of the master station are occupied for the number
of points of a remote I/O station. When areas in RWr and RWw should not be occupied, use the remote net Ver.2 mode. (Page 59
Mode)
Remote device station Remote I/O station
(Ver.1-compatible) (Ver.1-compatible)
Station No.1 Station No.2
RX
Range of
the station
No.1
RX
sending data
Range of
the station
No.2
sending data
RY
Station
No.1
RY
Station
No.2
RWr
Range of
the station
No.1
sending data
RWw
Station
No.1
Data sent from the master station
Data sent from slave stations
Intelligent device station
(remote net Ver.1 mode)
Station No.3
*1
RX
Range of the
station No.3
sending data
*1
RY
Station
No.3
RWr
Range of the
station No.3
sending data
RWw
Station
No.3
Area where data is sent to
other stations
4 FUNCTIONS
4.2 Cyclic Transmission
4
31