Setup; Setting The Initial Parameters For The Drive Unit; Servo Parameter - Mitsubishi Electric MDS-EX-CVP Series Technical Specification And Instruction Manual

MDS-EX-CVP Series Specifications and Instruction Manual

6. Setup

6. Setup

6.1 Setting the Initial Parameters for the Drive Unit

The servo and spindle related parameters must be set before the servo and spindle system can be started up. The
servo and spindle related parameters are input from the NC. The input method differs according to the NC being used,
so refer to each NC Instruction Manual.

6.1.1 Servo Parameter

(PR) #2236 SV036
MDS-E/EH Series: Power supply type
When connecting a power supply unit, set a code for each power supply unit.
bit F-C : amp
Set the power backup function to be used.
No function used: 0
Deceleration and stop function at power failure: 8
Retraction function at power failure: C
bit B-8 : rtyp
Not used. Set to "0".
bit 7-0 : ptyp External emergency stop setting
When the emergency stop input signal of the power supply unit is "disabled"
Power supply unit is not connected
MDS-E-CV-37 / MDS-EH-CV-37
MDS-E-CV-75 / MDS-EH-CV-75
MDS-E-CV-110 / MDS-EH-CV-110
MDS-E-CV-185 / MDS-EH-CV-185
MDS-E-CV-300 / MDS-EH-CV-300
MDS-E-CV-370 / MDS-EH-CV-370
MDS-E-CV-450 / MDS-EH-CV-450
MDS-E-CV-550 / MDS-EH-CV-550
When the emergency stop input signal of the power supply unit is "enabled"
(Note) Set the power supply rotary switch to "4".
Power supply unit is not connected
MDS-E-CV-37 / MDS-EH-CV-37
MDS-E-CV-75 / MDS-EH-CV-75
MDS-E-CV-110 / MDS-EH-CV-110
MDS-E-CV-185 / MDS-EH-CV-185
MDS-E-CV-300 / MDS-EH-CV-300
MDS-E-CV-370 / MDS-EH-CV-370
MDS-E-CV-450 / MDS-EH-CV-450
MDS-E-CV-550 / MDS-EH-CV-550
IB-1501587-A
PTYP Power supply type/ Regenerative resistor type
MDS-EH-CV-750
MDS-EX-CVP-1100H
MDS-EH-CV-750
MDS-EX-CVP-1100H
ptyp
rtyp
amp
: 00
: 04
: 08
: 11
: 19
: 30
: 37
: 45
: 55
: 75
: A0
: 00
: 44
: 48
: 51
: 59
: 70
: 77
: 85
: 95
: B5
: E0
24