Name Of Each Section - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

2.7

Name of Each Section

Shows the name of each section of the master/intelligent device module.
[3] 2-φ4.5 Mounting holes
[2]
[4]
[1]
[5]
[9]
[10]
No. Name
[1] Extension cable
[2] Dot matrix LED
[3] Direct mounting hole
[4] Operation status display LEDs
[5] Extension connector
[6] Name plate
[7] DIN rail mounting groove
[8] DIN rail mounting hook
[9] Pullout tab
[10] Power connector
[11] CC-Link connection terminal block
[6]
Top cover is removed
[11]
Description
Cable for connecting the module when adding the FX5-CCL-MS.
Displays the station number set in a module and the content of a test mode. (Page 24 LED display)
Screw holes (2-4.5, mounting screw: M4 screw) for direct installation
Indicates the operating status of the module. (Page 24 LED display)
Connector for connecting the extension cable of an extension module.
The product model name and manufacturer's serial number are shown.
The module can be installed on DIN46277 rail (35 mm wide).
Hook for mounting the module on a DIN rail of DIN46277 (35 mm wide).
They are used when drawing out an extension cable.
Connector for connecting the power cable. (Page 52 Power Supply Wiring)
Used to connect a Ver.1.10-compatible CC-Link dedicated cable. (Page 53 CC-Link Network Wiring)
Before installing or removing the terminal block, power off the module.
[7]
[8]
2.7 Name of Each Section
2 SPECIFICATIONS
23
2