Led Display - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

LED display

Indicates LED display.
LED name
L RUN
SD
RD
L ERR
POWER
RUN
ERROR
MST
B RATE 156K
625K
2.5M
5M
10M
Dot matrix LED
*1 The LEDs may look dimly lit or off depending on the communication status.
2 SPECIFICATIONS
24
2.7 Name of Each Section
LED color Description
Green Indicates the data link status.
On: Data link in progress
Off: Data link not performed
Green Indicates the data sending status.
On: Data being sent
Off: Data not sent
Green Indicates the data receiving status.
On: Data being received
Off: Data not receivedd
Red Indicates the data link error status.
On: A data link error has occurred at own station.
Flashing: Communication is unstable due to the following reasons.
• Terminating resistor is not connected.
• Affected by noise.
Off: Normal operation
Green Indicates whether the module is powered or not.
On: Power on
Off: Power off
Green Indicates the operating status.
On: Normal operation
Off: A hardware error or a watchdog timer error has occurred
Red Indicates the error status.
On: One of the following errors has occurred.
• All stations error was detected.
• Two or more master stations are connected on the same line
• Settings are incorrect
• A cable is disconnected or a transmission path is affected by noise
Flashing: A station with a data link error was detected. Or, the station number set for a remote station is already
in use.
Off: Normal operation
Green Indicates whether it is operating as a master station.
On: Operating as a master station
Off: Operating as an intelligent device station
Green Indicates the operating transmission speed.
On: Operating at the lit transmission speed
All off: Transmission speed auto-tracking (When succeeded, the LED of the followed transmission speed turns
on.)
Orange Displays the station number set in the module. In an offline or test mode, the following are displayed.
• Offline: "---"
• Line test: "L.T."
• Hardware test: "H.T."
*1
*1