Development Environment; Simplified Description Of Project Upgrade Steps; Figure 4: Fault Table Display - GE PACSystems RX3i Application Manual

The message provides the slot number (S08 in the example) in which the PROFINET Controller is installed, the
device number (D004) for the Bus A GCG, the serial bus address (SBA02) for the Genius device, and either Loss
of Device (LOD) or Addition of device (AOD).
3.4

Development Environment

The software components require Proficy Machine Edition, version 9.5 or later.
3.5

Simplified Description of Project Upgrade Steps

•
Convert the existing Series 90 project into an RX3i project.
•
Import Software Components for Dual Bus into the Proficy Machine Edition Toolchest.
•
Edit the Primary/Secondary Hardware Configurations.
•
Drag the Dual Bus application components from the Toolchest into the project's PLC Program Blocks.
•
Add/Edit the Dual Bus Application Blocks:
Add an instance of the ladder block BUSSES in _Main.
o
Enter GBusses for the name.
o
Edit INIT_GB00 in BUSSES to match the configuration of the Genius devices on the first dual
o
bus pair.
If there are more dual busses then:
o
▪
▪
▪
▪
▪
▪
GFK-2928

Figure 4: Fault Table Display

Copy, then paste the block named INIT_GBnn in BUSSES.
Rename INIT_GBnn by changing nn to the next bus number.
Edit the block contents to accommodate the configuration settings for the PNC,
GCG, and Genius device reference addresses.
Add a new instance of the function block DBUS.
Name the instance using DBnn by changing nn to the next bus number.
Repeat for the remaining busses, if any.
December 2017
Chapter 3. Application System Architecture
9