Upgrading The Branch Offices - 3Com VCX V7000 Maintenance Manual

------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
Upgrading the Branch
Offices
3 Enter these commands:
cd /opt/installtemp
tar xvf vcx-bss-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
4 Obtain a license key for the server. See
5 Install the license key. See
6 Change to the new software version by entering this command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. When the
reboot process has been completed, the system starts VCX 7.0.xc
services.
7 After the system has completed the restart process, verify that the
upgrade has occurred by entering the following command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output:
This section describes how to upgrade branch offices. Each branch office
is associated with a regional office.
As noted in Upgrading a Multi-Site VCX System with Branch
multi-site VCX systems can be categorized by the method used to
implement messaging.
In a multi-site VCX system configured to use local messaging, the IP
■
Messaging server is co-located with the IP Telephony server at each
branch office. In this case, each branch office provides messaging
services for its users.
Upgrading a Multi-Site VCX System with Branch Offices
Installing a License Key
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
Obtaining a License Key
File.
285
File.
Offices,