Upgrading The Primary Ip Telephony Server - 3Com VCX V7000 Maintenance Manual

Upgrading the
Primary IP Telephony
Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------
Follow the steps in this section to upgrade the primary IP Telephony
server.
1 To start the upgrade process, enter these commands on the primary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.xc
The system displays several status messages and provides prompts that
allow you enable Adhoc Conferencing and UPS Monitoring.
3 The Adhoc Conferencing prompt appears:
In order to support "ad-hoc" conferences with more than 3
participants, the Adhoc Conference Service is used.
service should be enabled on this server, unless another
server dedicated to Adhoc Conferencing will be used instead.
If available, a separate server typically provides greater
capacity and may be shared among sites.
Use the Adhoc service on this server? (Y/N) [Y]
If you want this server to act as a multi-caller (up to 6 callers)
conferencing server, enter
4 The UPS Monitoring prompt appears:
An Uninterruptible Power Supply (UPS) can be used with VCX
systems to avoid disruption due to a power outage.
provides a UPS monitoring service which tracks the UPS's
status and performs a safe shutdown when the its battery is
depleted during a long power outage.
you must have a compatible UPS installed and configured in
accordance with the VCX documentation.
Upgrading a Single-Site System With Four Servers
. If not, enter .
y n
This
VCX
To use this feature,
181
: