Upgrading The Primary Ip Telephony Server - 3Com VCX V7000 Maintenance Manual

266 A C: U
PPENDIX PGRADING
Upgrading the
Primary IP Telephony
Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
VCX S S
ERVER OFTWARE
Next, execute the following steps in the order listed:
Upgrade the primary IP Telephony server. See
■
Telephony Server.
Upgrade the primary IP Messaging server. See
■
IP Messaging Server.
Upgrade the secondary IP Telephony server. See
■
Secondary IP Telephony
Upgrade the primary IP Messaging server. See
■
Secondary IP Messaging
Set up database replication on the primary IP Telephony server. See
■
Up Database Replication.
Follow the steps in this section to upgrade the primary IP Telephony
server.
1 To start the upgrade process, enter these commands on the primary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Obtain a license key for the server. See
3 Install the license key. See
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.0.x IP
Telephony services.
F V6.0 V7.0
ROM TO
Server.
Server.
Installing a License Key
Upgrading the Primary IP
Upgrading the Primary
Upgrading the
Upgrading the
Obtaining a License Key
File.
Set
File.