3Com VCX V7000 Maintenance Manual page 210

210 A A: U
PPENDIX PGRADING
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------
VCX S S
ERVER OFTWARE
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
9 Repeat steps 1 through 8 for all the other branch office servers in
Region 1.
To upgrade the branch offices in Region 2 (global messaging):
1 Log in to the first branch office server as root.
2 Obtain a copy of the
and place it in the
server. The variable
vcx-all-7.1.3c.tar)
always appended to the version number.
3 To start the upgrade process, enter the following commands:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.xc
The system displays several status messages and provides prompts that
allow you enable Adhoc Conferencing and UPS Monitoring.
5 The Adhoc Conferencing prompt appears:
In order to support "ad-hoc" conferences with more than 3
participants, the Adhoc Conference Service is used.
service should be enabled on this server, unless another
server dedicated to Adhoc Conferencing will be used instead.
If available, a separate server typically provides greater
capacity and may be shared among sites.
F V7.0 V7.1
ROM TO
vcx-softswitch-7.1.xc.tar
directory on the branch office
/opt/installtemp
indicates the version of VCX software (for example,
y
that will replace the current version. The letter
software upgrade file
is
c
This