Set Up Database Replication - 3Com VCX V7000 Maintenance Manual

Set Up Database
Replication
1 Stop the Tomcat process, first on the primary IP Telephony server and
2 Set up replication on the primary IP Telephony server by entering these
Follow the steps in this section to set up database replication.
then on the secondary IP Telephony server by entering these commands
(log in as root):
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id
appears.
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary IP Telephony server and the
secondary IP Telephony server.
b The
Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE
Press Enter to accept the default.
c The
Enter the MASTER DEFINITION SITE IP Address [IP
prompt appears.
address]
Enter the IP address of the Master Definition site or press Enter if the
displayed address is correct. This is typically the IP address of eth0 on
the primary VCX server.
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0]
appears.
Enter the IP address of the Master Site. This is typically the IP address
of eth0 on the secondary VCX server.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter to continue. The script executes.
y
During script execution, messages appear describing the replication
setup. Messages also appear stating that firewall setup should allow
communication between the primary IP Telephony server and the
Upgrading a Single-Site System With Four Servers
[1]: prompt appears.
231
prompt
prompt