3Com VCX V7000 Maintenance Manual page 277

7 Enter these commands:
cd /opt/installtemp
tar xvf vcx-dataserver-7.0.xc.tar
cd upgrade-7.0.x
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
8 Obtain a license key for the server. See
9 Install the license key. See
10 Change to the new software version by entering this command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. When the
reboot process has been completed, the system starts VCX 7.0.xc
Authentication and Directory service.
11 After the system has completed the restart process, verify that the
upgrade has occurred by entering the following command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc).
Example Output:
12 Enter the following commands to stop the Authentication and Directory
server on Region 1:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
13 Log in, as root, to the Authentication and Directory server in Region 2.
14 Stop database replication by entering the following commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./dropReplication
The drop replication script starts. Follow the procedure described in
step 4.
Upgrading a Multi-Site VCX System with Branch Offices
Installing a License Key
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
Obtaining a License Key
File.
277
File.