Set Up Database Replication - 3Com VCX V7000 Maintenance Manual

6 Stop the Authentication and Directory service by entering the following
Set Up Database
Replication
1 Stop the Tomcat process, first on the primary VCX server and then on the
2 Set up replication on the primary VCX server by entering these
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Follow the steps in this section to set up database replication.
secondary VCX server by entering these commands:
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id
appears.
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary VCX server and the secondary VCX
server.
b The
Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE
Press Enter to accept the default.
c The
Enter the MASTER DEFINITION SITE IP Address [IP
prompt appears.
address]
Enter the IP address of the Master Definition site or press Enter if the
displayed address is correct. This is typically the IP address of eth0 on
the primary VCX server.
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0]
appears.
Enter the IP address of the Master Site. This is typically the IP address
of eth0 on the secondary VCX server.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Upgrading a Single-Site System With Two Servers
[1]: prompt appears.
177
prompt
prompt