Upgrading The Secondary Ip Messaging Server - 3Com VCX V7000 Maintenance Manual

186 A A: U
PPENDIX PGRADING
Upgrading the
Secondary IP
Messaging Server
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------
VCX S S
ERVER OFTWARE
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
7 Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Follow the steps in this section to upgrade the secondary IP Messaging
server.
1 To start the upgrade process, enter these commands on the secondary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
2 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.xc
The system displays several status messages and provides prompts that
allow you enable UPS Monitoring.
3 The UPS Monitoring prompt appears:
An Uninterruptible Power Supply (UPS) can be used with VCX
systems to avoid disruption due to a power outage.
provides a UPS monitoring service which tracks the UPS's
status and performs a safe shutdown when the its battery is
depleted during a long power outage.
you must have a compatible UPS installed and configured in
accordance with the VCX documentation.
Enable UPS monitoring? [N]
F V7.0 V7.1
ROM TO
VCX
To use this feature,
: