Set Up Database Replication - 3Com VCX V7000 Maintenance Manual

------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
2 Switch to the new software version by entering the following command:
3 After the system has completed the restart process, verify that the
4 Stop the Authentication and Directory service by entering the following
Set Up Database
Replication
1 Stop the Tomcat process, first on the primary VCX server and then on the
2 Set up replication on the primary VCX server by entering these
The system displays several status messages. The last two messages are:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.1.y
services.
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.yc
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Follow the steps in this section to set up database replication.
secondary VCX server by entering these commands:
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id
appears.
Upgrading a Single-Site System With Two Servers 223
prompt