Upgrading The Regional Call Records Server - 3Com VCX V7000 Maintenance Manual

284 A C: U
PPENDIX PGRADING
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
Upgrading the
Regional Call Records
Server
VCX S S
ERVER OFTWARE
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages
are:
b Obtain a license key for the server. See
c Install the license key. See
d Switch to the new software version by entering the following
command:
vcx-switchversion 7.0.xc
The system displays several status messages and then reboots. After
the reboot process has been completed, the system starts VCX 7.0.x
Call server.
e After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
4 Upgrade the secondary Call server by following the procedure described
in step 3.
5 Repeat steps for the other regions in your VCX system.
This section describes how to upgrade regional Call Records server. In a
multi-site VCX system, a single Call server typically supports all regional
offices. You need to perform the steps in this section on a console
attached to the regional Call server.
To upgrade the Call Records server:
1 Log in to the Call Records server as root.
2 Obtain a copy of the
place it in the
/opt/installtemp
F V6.0 V7.0
ROM TO
Installing a License Key
vcx-bss-7.0.xc.tar
directory on the Call Records server.
Obtaining a License Key
File.
software upgrade file and
File.