Upgrading The Secondary Vcx Server - 3Com VCX V7000 Maintenance Manual

6 Stop the Authentication and Directory service by entering the following
7 Stop IP Messaging. When the primary VCX server reboots, IP Messaging
8 If the returned status is
Upgrading the
Secondary VCX
Server
1 To start the upgrade process, enter these commands on the secondary
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
2 Obtain a license key for the server. See
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
restarts and must be stopped before you can upgrade the secondary VCX
server. However, you should ensure IP Messaging is fully active before
stopping it. To check IP Messaging status, enter the following commands:
su - app
cd /opt/3com/VCX/UMS/vcx-scripts/init.d
./vcxums status
the following commands:
exit
cd /opt/3com/VCX/scripts/rc3.d
./S60ums stop
Follow the steps in this section to upgrade the secondary VCX server.
VCX server:
cd /opt/installtemp
tar xvf vcx-all-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
Upgrading a Single-Site System With Two Servers
, stop IP Messaging by entering
...running...
Obtaining a License Key
261
File.