Installing The Memory; Checking The Contents; Checking Before Memory Expansion; Turning Off The Power Of The Host Machine - Canon iR C1020 Series Service Manual

5) Install the 3 wire saddles [1] and secure the route cord part [2] of the hand
set with the 3 wire saddles [1].
[1] [2]
6) Connect the terminal [1] of the cord to the modular terminal "
host machine.
[1]
F-2-29
[1]
F-2-30
"[2]of the
[1] [2]
7) Turn on the main power switch.
8) Check that you can hear the dial tone through the handset.

2.7 Installing the Memory

2.7.1 Checking the Contents

<System Upgrade RAM-A1>
[1]
[1] Expansion memory

2.7.2 Checking Before Memory Expansion

1) Enter service mode and output the spec report.
COPIER > FUNCTION > MISC-P > OUTPUT > SPEC
2) Check the memory capacity before installing the extension RAM with
'TOTAL MEMORY' of the spec report.
3) Exit service mode.

2.7.3 Turning OFF the Power of the Host Machine

Be sure to refer to "Points to Note When Turning OFF the Main Power" in
installation of the host machine.

2.7.4 Installation Procedure

1) Remove the cover plate [1] at the rear cover.
- 1 claw [2]
Chapter 2
F-2-31
F-2-32
1pc.
0019-6871
0020-1946
0019-6883
0019-6885
2-11