Canon imageRUNNER 2525 Series Service Manual page 350

5. Insert the system upgrade RAM in the slot where the
256MB RAM has been detached.
NOTE:
Be sure the upgrade memory has firmly been inserted and
the hooks are in the hole of the memory as shown in the
figure.
6. Install the controller cover.
• 3 Screws (TP; M3x6)
7. Install the rear cover (right).
• 3 Screws (RS tightening; M3x8)
8. Connect the power plug of the host machine to the
power outlet and turn its main power switch ON.
9. Checking the Connection.
10. Enter the service mode.
11. Use left or right cursor [< / >] key and press [OK]
when [REPORT] has appeared.
12. Use left or right cursor [< / >] key and press [OK]
when [REPORT OUTPUT] has appeared.
13. Use left or right cursor [< / >] key and press [OK]
when [SPEC LIST] has appeared.
14. SPEC REPORT is printed out. Confirm TOTAL
MEMORY is [512MB] on the report.
340
9. Installation