12. Secure the card reader cover.
• 1 Screw (Binding ; M4x6)
1x
13. Remove the cover of Harness cover and then
remove the release paper.
14. Affix the Harness Cover (bases) at the right rear of
the machine with it aligned with the bottom line of
the reader as the figure below.
15. Attach the 2 Wire Saddle at the position shown in the
figure.
16. Connect the relay harness B to the card reader
harness, and then connect the connector of the relay
harness B to the relay harness C so that the
connector without the protective tube of the relay
harness B can be connected.
1x
328
9. Installation