Canon imageRUNNER 2525 Series Service Manual page 238

Hide thumbs Also See for imageRUNNER 2525 Series:
Table of Contents

Advertisement

Detailed Discussions of Bit 3
Use it to select an appropriate reception mode after transmission of the CFR signal.
If errors occur frequently at time of reception because of the condition of the line, select 'high speed' for reception mode and, at
the same time, selects 'do not receive' for 'ECM reception.'
NOTE:
Any of the following error codes may be indicated at time of reception because of line condition
##0107, ##0114, ##0201
Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.
When 'high speed' is selected, only high-speed signals (images) will be received after transmission of the CFR signal.
Detailed Discussions of Bit 4
Use it to select the time length during which low-speed signals are ignored after transmission of the CFR signal.
If the condition of the line is not good and, therefore, the reception of image signals is difficult, select '1500 ms.'
Detailed Discussions of Bit 5
In the countries that need approval of CI signal frequency check, no checking on frequency set at PBX when changing the
frequency to PSTN setting and PBX setting for frequency checks.
Detailed Discussions of Bit 6
Selects whether or not to transmit CNG signal during manual transmission.
In manual transmitting to a fax with the FAX/TEL switching mode, if there are frequent errors due to failure to switch to fax mode,
select "Transmitted" for the CNG signal.
Detailed Discussions of Bit 7
Selects whether or not to transmit CED signals during manual reception.
If the other fax does not transmit even when you start manual reception, select "Transmitted" for the CED signal.
● SSSW-SW05
List of Functions
Bit
0
not used
1
Conversion from mm to inch (text mode)
2
Conversion from mm to inch (text/photo mode) execute
3
transmit bit 33 and thereafter for DIS signal
4
Recording paper length availability declared in
DIS signal
5
not used
6
not used
7
not used
Function
228
1
-
execute
prohibit
A4 /B4 size
-
-
-
8. Service Mode
0
-
do not execute
do not execute
do not prohibit
Arbitrary size
-
-
-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Imagerunner 2520 seriesImagerunner 2530 series

Table of Contents