Canon imageRUNNER 2525 Series Service Manual page 385

27. Attach the following removed parts.
Power supply unit (2 Screws, Connectors (ALL))
Left cover (1 Screw) (Except for Europe model)
Left cover (2 Screws) (Only for Europe model)
Inside base cover (1 Screw (Attach it to the left
cover.))
Left rear cover (3 Screws)
Left rear face cover (1 Screw)
Left cover (lower) (2 Screws) (For 550 sheets cassette
model)
Left cover (lower) (3 Screws) (For 250 sheets cassette
model)
Rear lower cover (1 Screw)
Connector cover (1 Screw)
Rear cover (right) (3 Screws)
Toner replenish cover (2 Screws)
28. Insert the developing unit.
• 1 Connector
1x
29. Hold the drum unit handle and the part shown in the
figure. Slowly insert it until it stops.
CAUTION:
Confirm that the drum unit engages to the rail of the
host machine.
30. Turn the developing pressure lever to set the
developing unit.
31. The screw is not necessary if it is not removed at the
step 4.
1x
32. Attach the waste toner container.
33. Turn the lock lever to fix the container.
34. Close all the covers.
35. Connect the power plug of the host machine to the
outlet.
375
9. Installation