Canon imageRUNNER 2525 Series Service Manual page 246

Details of [Bit 3]
To set whether to display the Waste Toner Container preparation warning message in the status area of LUI.
Selecting "1" displays the warning. (Initial value)
Selecting "0" does not display the warning.
Details of [Bit 4]
To set whether to display the Toner Bottle replacement warning message in the status area of LUI.
Selecting "1" displays the warning. (Initial value)
Selecting "0" does not display the warning.
NOTE:
To notify the waste toner full warning in the status line of the Control Panel, set "1" for Bit 0 and Bit 3 of SW34.
● SSSW-SW35
Not used
Bit
0 e-RDS function ON/OFF
1 Call button function ON/OFF
2 ScanToMedia function enable/disable
Default: 0
3 MediaPrint function enable/disable
4 IC card authentication management function ON/OFF
5 Handling of a scan job at device logout
Default: 0
6 Handling of display of the stop confirmation screen when the
stop key is pressed during a scan job, except remote scan
7 Switching to display/hide the start button of the counter print
(known as billing counter report)
Default: 1
Detailed Discussions of Bit 0
Select whether to set the e-RDS function.
When "1" is selected, the function is set.
When "0" is selected, the function is not set.
Detailed Discussions of Bit 1
Select whether to enable the service call request function and display the Service Call Request button.
When "1" is selected, the function is enabled and the button is displayed.
When "0" is selected, the function is disabled and the button is not displayed.
CAUTION:
In the case of a model for USA, the button will not be displayed even if "1" (enabled) is selected.
Detailed Discussions of Bit 2
Select whether to enable or disable the ScanToMedia function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
Detailed Discussions of Bit 3
Select whether to enable the MediaPrint function.
When "1" is selected, the function is enabled.
When "0" is selected, the function is disabled.
Function 1
Yes
Yes
enable
enable
Yes
Stop a scan job
Not display the stop confirmation
screen (same specification as
that of the existing models)
Display the counter print button Hide the counter print button
236
8. Service Mode
0
No
No
disable
disable
No
Not stop a scan job
Display the stop confirmation
screen (the display specification
following that of the iR series)