Motor
Removing the Main Motor (M1)
■ Preparation
1. Remove the rear cover
Cover (Right)" on page 136
2. Remove the rear cover
Cover (Left)" on page 137
3. Remove the right cover (upper
Rear Right Cover (Upper)" on page 137
4. Remove the HVT
PCB."Removing the HVT PCB" on
page 173
■ Procedure
1. Remove the main motor.
• 4 screws
• 1 connector
4x
Removing the Fixing Motor
(M2)
■ Preparation
1. Remove the rear cover
Cover (Right)" on page 136
2. Remove the rear cover
Cover (Left)" on page 137
3. Remove the right cover (upper
Rear Right Cover (Upper)" on page 137
(right)."Removing the Rear
(left)."Removing the Rear
rear)."Removing the
1x
(right)."Removing the Rear
(left)."Removing the Rear
rear)."Removing the
■ Procedure
1. Remove the support plate.
• 1 relay connector
• 1 connector
• 1 screw
1x
NOTE:
Because there is a screw on the backside of the relay
connector, remove the relay connector earlier.
2. Disconnect all connectors on the DC controller PCB.
159
4. Disassembly/Assembly
1x