7. Connect the RS Conversion PCB and the CV-Serial
Relay Cable, and install the RS232C Support Plate
by aligning the 2 Protrusions on the plate with the
holes on the host machine.
• 2 Screws (TP; M3x6)
• 2 Protrusions
• 2 Holes
TP ; M3X6
2x
1x
8. Be sure to put the harness [A] between the RS
Conversion PCB and the plate [B] with the tie-wrap
[C] of it on the front side.
[A]
[A]
[B]
[B]
[C]
[C]
9. Install the Controller Cover.
Protrusion
Hole
Hole
Protrusion
[A]
[A]
[B]
[B]
334
10. Install the Rear Cover (Right).
11. Install the Power Plug.
12. Install the Power Supply Retainer.
13. Turn ON the main power switch.
9. Installation