17. Connect the connector of the relay harness C to the
connector J8119 on the main controller PCB.
1x
18. Secure the relay harness C to the 8 Wire Saddles
from the reader side, and route the relay harness C
shown in the figure.
CAUTION:
Put the core between Wire Saddles shown in the
Figure.
8x
19. Using the harness cover (lids), secure the relay
harness B to the harness covers (bases).
20. Using a side cutters, remove the precut portion of
the rear cover (left) as shown below.
CAUTION:
When cutting off the part, be sure not to make burrs.
21. Attach the rear cover(left). (2 Screws)
Core
329
9. Installation