Canon imageRUNNER 2525 Series Service Manual page 354

2. Only for Europe model
• 2 Screws
2x
10. Install the Heater SW Harness firmly in the power
cord bracket.
NOTE:
Install the Heater SW harness in the correct direction
referring to the figure in the power cord bracket.
11. Put the longer harness of the Heater SW Harness out
of two through the hole of the rear frame.
12. Connect the connector of the longer harness of the
Heater SW Harness to J108 of the power supply unit.
• 1 Connector
1x
344
9. Installation