Chapter 2
- DADF-L1 + Finisher-Z1 + Paper Deck-Z1
- DADF-L1 + Saddle Finisher-Y2 + Puncher Unit-L1/M1/N1/P1 + Buffer Pass Unit-E2 + Paper deck-Z1
7) The machine must be placed in a well ventilated area. It is important to make sure, however, that the machine is not near the air vent (for suction) of the room.
2.1.2 Check to Make Before Installation
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR C3080 / iR C3080i / iR C2380i
Be sure to go through the following before starting the work:
1) If you are installing the machine after moving it from a cold to warm location, be sure to leave the machine unpacked for at least 2 hours so that the machine is
fully used to the site temperature, thus avoiding image faults caused by condensation.
(The term "condensation" refers to the formation of droplets of water on the surface of a metal object brought in from a cold to warm place, i.e., as the result of
the rapid cooling of the moisture (vapor) around the object.)
2) The machine weighs a maximum of about 125 kg (including a DADF). Be sure to work in a group of 4 persons when lifting it.
Also, lift the main body while keeping it level.
2.1.3 Combination Table of Accessory Installation
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR C3080 / iR C3080i / iR C2380i
The following table shows the combination of accessories that are set at the right side of the host machine.
When setting the accessories indicated in the table, refer to the table below and check the combination before the setup.
Document Tray-J1
Voice Guidance Kit-B1
Voice Operation Kit-A1
Card Reader-C1
yes: Available no: Unavailable
2-2
4" (100 mm) or more
19" 3/4 (500 mm)
or more
4" (100 mm) or more
19" 3/4 (500 mm)
or more
89" 1/4 (2,268 mm)
Document Tray-J1
Voice Guidance Kit-B1
-
no
no
yes
19" 3/4 (500 mm)
or more
63" 3/8 (1,610 mm)
F-2-3
19" 3/4 (500 mm)
or more
F-2-4
T-2-1
Voice Operation Kit-A1
no
no
-
no
no
yes
yes
Card Reader-C1
yes
yes
-
yes
-
0013-8398
0014-5103