Reflect Mode-Mounting Frames And Spacer Bar - Siemens SITRANS FUH1010PVDX Operating Instructions Manual

Section 3
3.3.6 REFLECT MODE - MOUNTING FRAMES AND SPACER BAR
The combination of a spacer bar with mounting frames is the easiest way to mount in Reflect Mode. The
result is a rigid structure that eliminates spacing measurements, and maintains the transducer-to-trans-
ducer geometry. In addition, reflect mounting allows you to move the entire assembly while maintaining
the original transducer spacing.
Space Bar Platform &
Clamping Screw
Mounting Frame
Transducer shown
in the 9 o'clock
position on pipe
INSTALLATION - REFLECT MOUNT WITH FRAMES AND SPACER BAR
Orientation for
Single Beam
Transducer at
9 o'clock position
Transducer Clamping
Transducer Clamping
Spring Clip
Spring Clip
(Not present on some
(Not present on
models)
some models)
Front View
1. Perform all required menu steps until the flow computer issues the number index and prompts you to
press <ENT> to finish the transducer install routine. Stop at this point.
Note the number index value displayed in the Pick/Install menu. You will use this number to properly
space the transducers. Check to ensure that you have a matched set of transducers. They both should
Mounting Frame
Front View
Mounting Strap
positioned around
Mounting Frame
NOTE: Minimum Ltn 0.75 in. (18 mm)
Orientation for
Dual Beam
Transducer at
10 & 2 o'clock
positions
Spacer Bar Spacer Bar
Screw
Screw
Spacer Bar
Reference Hole
3-8
Space Bar
(Front View)
Metal Post
Optional: On larger pipes,
multiple lengths of straps can be
linked together to surround pipe.
Spacer Bar
Spacer Bar
Platform and Platform and
clamping screw
clamping screw
CQO:1010PVXFM-3
Mounting Strap
Adjusting screw
1012 Series
1012 Series
Mounting Frame
Mounting Frame
Mounting Strap Mounting Strap
Note: Operational
Note optional 2nd
2nd Mounting Strap
Mounting Strap
shown. shown.
Larger pipes may Larger pipes may
need an additional
need an additional
strap for a more
strap for a more
secure mount
secure mount.