Data Display Mode - Siemens SITRANS FUH1010PVDX Operating Instructions Manual

Section 2

Data Display Mode

After you complete the installation, you can toggle between Installation Menu mode to Data Display
mode. This is the same as using the <MENU> key on the keypad (see manual). The PC keyboard equiva-
lent to the <MENU> key is <CNTRL> + <L>. Note that the RS-232 interface does not support graphics.
Therefore, when you use HyperTerminal to view the data display screens, you will see the same data in
alphanumeric form only (as shown below). You can still use the <Up Arrow> and <Down Arrow> to
switch between available display screens.
This is the current flow
This is the current flow
reading and flow units.
reading and flow units.
(This would be a large
(This would be a large
graphic characters on
graphic character on
the1010 screen.
the 1010 scree
n
This is the flow
This is the flow
Total display
total display.
2-21
CQO:1010PVXFM-3
This is the name of the current active
This is the name of the current active
site setup. The [1] indicates that
site setup. The [1] indicates that the
measurement channel is currently
measurement channel is currently
active.
active.
This is the current measured liquid
This is the current measured liquid
sonic velocity (Vs).
sonic velocity (Vs).