Reflect Mode-Mounting Frames And Spacer Bar - Siemens SITRANS FUG1010 IP65 NEMA 4X Instruction Manual

Section 5
5.2 REFLECT MODE - MOUNTING FRAMES AND SPACER BAR
The combination of a spacer bar with mounting frames is the easiest way to mount in Reflect Mode. The
result is a rigid structure that eliminates spacing measurements, and maintains the transducer-to-trans-
ducer geometry. In addition, reflect mounting allows you to move the entire assembly while maintaining
the original transducer spacing.
Mounting Strap
positioned around
Mounting Frame
Optional on larger
pipes, you can link
straps to surround pipe
INSTALLATION - REFLECT MOUNT WITH FRAMES AND SPACER BAR
Transducer Clamping
Transducer Clamping
Spring Clip
Spring Clip
(Not present on
(Not present on some
some
models)
models)
Perform all required menu steps until the flow computer issues the number index and prompts you to
1.
press to finish the transducer install routine. Stop at this point.
ENT
Note the number index value displayed in the Pick/Instal
space the transducers. Check to ensure that you have a matched set of transducers. They both should
have the same S/N number but marked with either an "A" or "B" (e.g., 100A and 100B).
NOTE: Minimum Ltn 0.75 in. (18 mm)
Spacer Bar
Spacer Bar
Screw
Screw
Spacer Bar
Spacer Bar
Platform and Platform and
clamping screw
clamping screw
You will use this number to properly
l menu.
5-4
1010GCNFM-3C
Spacer Bar Platform &
Clamping Screw
Space Bar
(Front View)
Mounting Strap
Adjusting Screw
1012 Series
1012 Series
Mounting Frame
Mounting Frame
Mounting Strap Mounting Strap
Note operational
Note optional 2nd
2nd Mounting Strap
Mounting Strap
shown.
shown.
Larger pipes may
Larger pipes may
need an additional
need an additional
strap for a more
strap for a more
secure mount
secure mount.