Data Bits; Line Feed; Network Id - Siemens SITRANS FUH1010PVDX Operating Instructions Manual

Section 5
To edit the Parity setting:
To access the [Parity] option list press
Move the cursor to the required parity setting by pressing
To store the data press

Data Bits

You can specify how many data bits the meter uses to format data words for serial transmissions. The
default setting is [7]. (Note that the 996P portable printer requires a word length of [8].)
To set the Data word length:
To access the [Data Bits] option list press
To move the asterisk to the required bit setting press
Press to store data. This moves the cursor to [Line Feed].
ENT

Line Feed

Some serial devices (printers, terminals, etc.) insert a line feed automatically after they receive a car-
riage return character. When communicating with these device types, you should set the [Line Feed]
menu cell to [OFF]. This instructs the flow computer to send a carriage return character without adding a
line feed to avoid creating an additional blank line after each carriage return. Setting the [Line Feed] to
[ON] tells the flow computer to insert a line feed character after each carriage return that it transmits.
This may be necessary to avoid the constant "wrapping" of transmitted data onto a single line. The
factory setting is [NO] (line feed disabled). Note that the 996P portable printer requires [NO].
To enable (or disable) Line Feed:
To access the [Line Feed] option list press
Press
To store the data press

Network ID

The [Network ID] menu cell stores an identification number to facilitate host computer polling when you
use this system in a network environment. The Network ID number can be any value other than 0 (zero).
The default setting, zero, disables the network function. Note that entering a non-zero Network ID num-
ber suspends all routine Datalogger activity regardless of any selected options.
NOTE: If you are using the flowmeter for a "stand-alone" application, you must keep the zero
Network ID number.
. This moves the cursor to [Data Bits].
ENT
to move the asterisk to [Yes] Line Feed enabled, or [No] Line Feed disable.
. This moves the cursor to [Network ID].
ENT
5-79
CQO:1010PVXFM-3