Reset Totalizer; The Data Span/Set/Cal Menu - Siemens SITRANS FUH1010PVDX Operating Instructions Manual

Section 5
To enter a Batch/Sample Volume:
To activate numeric entry press
Use PC numeric keys or Magnetic Wand to enter the desired Batch/Sample TOT accumulation.
To store data press

5.6.10 RESET TOTALIZER

Use this function to set all FUH1010PVX totalizer registers, including the overflow register, to zero. For
details, see your model's installation drawings. Full totalizer control over these registers is also obtain-
able with a PC using the menu access facility (see Totalizer Controls).
5.7

THE DATA SPAN/SET/CAL MENU

This menu becomes available after picking a Meter Type and Measurement Channel. However, some
functions will only be active after the transducers are installed and operating properly.
Use the [Data Span/Set/Cal] menu to set the range for analog outputs and setpoints for Alarm relay
outputs. Additionally, the [Calibrate Flow Rate] menu allows you to apply external adjustments to the
meter's intrinsic primary outputs.
Use this menu to set the
low and high range for
analog outputs.
Use this menu cell to
enter a calibration
slope factor for
volumetric flow (Vfo).
Use these menu cells to
enter Index Variables and
their Set Points, activate
and clear tables.
ENT
Siemens Dual Path
Define data Alarm thresholds
Span Data
Set Alarm Levels
Calibrate Flowrate
Calib. Table 1
Calib. Table 2
Calib. Table 3
Data Span/Set/Cal
SITE1
Intrinsic
5-45
CQO:1010PVXFM-3
Use this menu to define
setpoints for the alarm
relay outputs.