Siemens SITRANS FUH1010PVDX Operating Instructions Manual page 109

Section 5
Use this menu
cell to edit the
pipe outer
diameter.
Use this menu
cell to edit the
pipe material.
Use this menu
cell to edit the
wall thickness.
Use this menu to
change the Modulus
of Elasticity of the
Pipe Wall.
The default value for each of these new parameters is 0.0. A value of zero effectively disables the
pressure and temperature pipe volume compensation routine. When entering a value for the thermal
expansion coefficient and modulus of elasticity, keep in mind that the numeric entry already includes an
exponent multiplier. For the Thermal Expansion Coefficient the multiplier is 10
Elasticity the multiplier is 10
Typical values for each parameter are shown below:
Mild Carbon Steel
NOTE: Do not enter exponents of above values.
Siemens
Select Pipe Class from Pipe Table
Select Path
Select Pipe Class
Select Pipe Size
Pipe OD <in>
Pipe Material
Wall Thickness
Liner Material
Liner Thickness
ThermExp Coef 1/F
Mod of Elast PSI
Pipe Data
.
6
Pipe Material Thermal Expansion Coef
6.20 x 10
(11.16 x 10
304 Stainless 9.60 x 10
(17.28 x 10
316 Stainless 8.83 x 10
(15.89 x 10
Dual Path ABC
All
Manual Entry
No Pipes
0.500
Steel
0.100
None
0.000
0.00
0.000
-6 -1
F
-6 -1
C )
-6 F -1
-6 -1
C )
-6 F -1
-6 -1
C )
5-7
CQO:1010PVXFM-3
Use this menu cell to select a Pipe
Class from one of the meter's presets.
The [Manual Entry] selection (default)
means that you enter pipe data
manually.
After picking a pipe class,
use this menu cell to
select a pipe from within
that class.
Use this menu cell to
select a pipe liner
material.
Use this menu cell to edit
the pipe liner thickness.
Use this menu cell to edit
the Thermal Expansion
Coefficient of the pipe
-6
wall (x10 ).
and for the Modulus of
-6
Modulus of Elasticity
6
30 x10 psi
6
2.07 x 10 bar
28 x10 6 psi
6
1.93 x 10 bar
28 x10 6 psi
6
1.93 x 10 bar