Connector Types - Basler A202K Manual

6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Pin
Number
[1]
1, 2
3
4
[2]
5, 6
[1]
Pins 1 and 2 are tied together inside of the camera.
[2]
Pins 5 and 6 are tied together inside of the camera.
Table 2-2: A202
Figure 2-2: A202

2.1.3 Connector Types

The 26 pin connector on the camera will be a female .050" MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera will be a Hirose micro-miniature locking receptacle (part #
HR10-7R-6PA) or the equivalent. The recommended mating connector is the Hirose micro-
miniature locking plug (part # HR10-7P-6S). A Hirose locking plug will be shipped with each
camera. This plug should be used to terminate the cable on the power supply for the camera. For
proper EMI protection, the power supply cable attached to this plug must be a twin-cored, shielded
cable. Also, the housing of the Hirose plug must be connected to the cable shield and the cable
shield must be connected to earth ground at the power supply.
k
BASLER A202
Signal
Direction
Name
12 V In Input
Input
DC Gnd
Pin Assignments for the 6-pin Micro-miniature Receptacle
k
Pin Numbering
k
DRAFT
Level Function
+12 VDC Camera Power Input
Not Connected
Not Connected
Ground DC Ground
1 6
5
2
3 4
13 1
26
14
Camera Interface
2-3