Toshiba e-STUDIO6520C Service Handbook page 285

Notes:
If LED 3 does not light, follow the procedure
below.
1. Tighten 2 prism vertical fixing screws
aligning with the forth mark-off line from
the top.
2. Loosen the 2 prism horizontal adjustment
screws.
3. Slide the prism horizontally. When the
prism comes to the proper adjustment
position, LED 3 on the RADF board lights.
At this position, tighten 2 prism horizontal
adjustment screws.
(7) Perform the automatic adjustment (05-356).
Note:
After the manual adjustment is performed, be sure to do the automatic one.
(8) Turn the power OFF and install the cover.
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-72
Fig. 3-73
Fig. 3-74
3 - 87
e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3