Toshiba e-STUDIO6520C Service Handbook page 582

(4) Press the [ON/OFF] button while simultaneously holding down the [4] and [9] buttons.
Data in the USB media are checked and the checking status is displayed on the screen.
The screen for selecting items to be updated is displayed after approx. 1 minute.
On this screen, the current firmware version of this equipment and the firmware version of data to
be updated are displayed.
Notes:
• The display of items on this screen varies depending on the types of data written on the USB
media. Each item is displayed only when each data file is written on the USB media in the
following conditions.
1. OS Update
2. HDD SYS Update
3. PFC Firmware Update
4. Engine Main Firmware Update
5. Scanner Firmware Update
6. MEP Firmware Update
• If the USB media are not recognized properly, "Set Correct USB Storage Device" message is
displayed. In this case, disconnect the USB media and connect it again within 3 minutes, or
shut down the equipment and connect the device properly. Then repeat the procedure from
(4).
• If any of the error messages below is displayed, confirm if the update program or the data file
in the USB media is correct. Then repeat the procedure from (4)
Error
number
- There is no mentusb2.o
01 There is no dlFirmWare_5520C_6530C
02 Error Loadmodule
03 Machine Model Get Error
04 Please Change USB Storage or Please Check
ROMDATA
05 Other models ROMDATA Vxxxx.xxx x
* The version name comes at "xxxx.xxx.x".
e-STUDIO5520C/6520C/6530C
FIRMWARE UPDATING
Item
For the details, see the following page:
P.8-7 "8.1.1 Master data/System ROM/PFC ROM/
Engine ROM/Scanner ROM"
• The Imaging Acceleration Board (GE-1170,
optional) must be installed.
• T430IWW.xxx is written.
*
Error message
Fig. 8-10
Condition
xxx is version.
Update program loader (mentusb2.o) is
not stored.
Model specific update program
(dlFirmWare_5520C_6530C) is not stored.
Module loading failed.
Model information was not downloaded.
Checking of data file failed.
Master data of other model (hdd.bin) are
stored.
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 18
Cause