[I]
Set EFI Printer Board
If the EFI Printer Board (GA-1310) is installed, perform the following procedure.
(1)
Turn the power OFF.
(2)
Start the setting mode (08).
(3)
Initialize the EFI Printer Board (08-700).
(4)
Turn the power OFF.
[J]
Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
•
Meta Scan Enabler (GS-1010)
•
External Interface Enabler (GS-1020)
•
IPSec Enabler (GP-1080)
When GP-1070 (Data Overwrite Enabler) has been installed, "F200" service call occurs. In this case,
perform cancelling the "F200" service call (installing the OS / HDD SYS / PFC Firmware / Engine
MainFirmware / Scanner Firmware using the USB media), and then install GP-1070 (Data Overwrite
Enabler) again.
e-STUDIO5520C/6520C/6530C
REPLACEMENT OF PC BOARDS/HDD
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
7 - 32