Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

5.4.2

Communication detail settings

Make the settings according to the usage environment.
Item
Transmission Speed
Data Bit
Stop Bit
Parity
Retry
Timeout Time
Host Address
*1
Delay Time
32bit Storage
FunctionCode[0F]
FunctionCode[10]
Coil read times
Input relay read time
Holding register read times
Input register read times
Coil write times
Holding register write times
Description
Set this item when change the transmission speed used for communication with
the connected equipment.
(Default: 19200bps)
Set this item when change the data length used for communication with the
connected equipment.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed during
communication.
(Default: Even)
Set the number of retries to be performed when a communication error occurs.
(Default: 3times)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the host address in the network of the GOT.
(Default: 1)
Set this item to adjust the transmission timing of the communication request from
the GOT.
(Default: 0ms)
Select the steps to store two words (32-bit data).
(Default: LH Order)
Select the FunctionCode [0F].
(Default: Used)
Select the FunctionCode [10].
(Default: Used)
Set the Coil read time.
(Default: 2000)
Set the Input relay read time.
(Default: 2000)
Set the Holding register read times.
(Default: 125)
Set the Input register read times.
(Default: 125)
Set the Coil write times.
(Default: 800)
Set the Holding register write times.
(Default: 100)
Range
9600bps, 19200bps, 38400bps,
57600bps, 115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
0 to 5times
1 to 30sec
1 to 247
0 to 300ms
LH Order/HL Order
Used/Unused
Used/Unused
1 to 2000 points
1 to 2000 points
1 to 125 points
1 to 125 points
1 to 1968 points
1 to 123 points
5.4 GOT Side Settings
5
5 - 13