Mitsubishi Electric GOT2000 Series Connection Manual page 284

■2. PLC Side Setting
Make the communication settings as shown below. For details of the communication settings, refer to the following
manual.
➠
(1) Modbus Communication Portfolio License
To set the communication settings for STARDOM, an installation of Modbus Communication Portfolio License is
required.
For details of the communication settings, refer to the following manual.
➠
(2) Defining Logic POU
Define Logic POU using Logic Designer (peripheral software), and download the project to STARDOM.
(a) Start Logic Designer and create a new project using a template.
Use [STARDOM Serial Communication] template.
(b) Insert Firmware Library to the new project.
• Right-click [Library] under the project tree in Logic Designer.
• Right-click [Insert] and select [Firmware Library].
• Double-click the [SD_FCXPLCE_LIB] folder and double-click [SD_FCXPLCE_LIB.fwl] to select it.
• The library path inserted in the procedures above is as follows.
{Install Folder}\LogicDesigner\Mwt\Plc\Fw_lib\SD_FCXPLCE_LIB\SD_FCXPLCE_LIB.fwl
(c) Insert User Library to the new project.
• Right-click [Library] under the project tree in Logic Designer.
• Right-click [Insert] and select [User Library].
• Double-click [SD_CMODBUSE_PF.mwt], [SD_CUTIL_PF.mwt] and [SD_CMODBUSS_PF.mwt] to select it.
(When [STARDOM Serial Communication] is used for the template, [SD_CUTIL_PF.mwt] is inserted as
default.)
• The library path inserted in the procedures above is as follows.
{Install Folder}\LogicDesigner\Libraries\SD_CMODBUSE_PF.mwt
{Install Folder}\LogicDesigner\Libraries\SD_CUTIL_PF.mwt
{Install Folder}\LogicDesigner\Libraries\SD_CMODBUSS_PF.mwt
(d) Copy a sample project POU to the new project.
• Open "SD_CMODBUSE_Sample1.mwt".
• Right-click [ComEServerModbus*] in the Logic POU under the project tree in the SD_CMODBUSE_Sample1
project, and select [Copy].
• Right-click the [Logic POU] under the project tree in the previously created project, and select [Paste].
• Double-click the [ComEServerModbus*] file in the [ComEServerModbus*] folder.
• For the following terminals, set as shown below.
6 - 16
6.6 Example of Connection
Peripheral Software Manual for YOKOGAWA PLC
POINT POINT POINT
Connection between STARDOM and the PC for communication settings
For the communication settings of STARDOM, STARDOM and the PC for communication
settings must be connected to Ethernet using the Resource Configurator (peripheral software).
STARDOM FCN/FCJ Guide