System Configuration Examples - Mitsubishi Electric GOT2000 Series Connection Manual

2.7

System Configuration Examples

The following shows a system configuration example in the case of the microcomputer connection (serial).
■1. System configuration
The system configuration example illustrated below is explained in this section.
■2. Communication settings on GOT side and monitor screen settings
(1) Transmission settings
Set the transmission settings of the GOT.
The transmission settings in the microcomputer connection (serial) are made at [Detail Setting] on GT Designer3.
➠
Setting item
Baud rate
Data bit
Stop bit
Parity
Interrupt Data Byte
Host address (0 to 31)
Format
Special Interrupt Code
Control Method
32bit Storage
(2) Monitor screen settings
The following shows the monitor screen settings in this system configuration example.
(a) Common settings
Set D20 to the screen switching device (base screen).
Step 1.
Select [Common]
[Environment Setup] on GT Designer3.
Step 2.
Set D20 to the screen switching device (base screen).
2 - 86
2.7 System Configuration Examples
2.6.2 Communication detail settings
[GOT Environmental Setting]
IBM-PC/AT-compatible PC
(Microsoft Visual C++ Ver.6.0)
Setting details
38400bps
LH Order
[Screen Switching/Window] to display
8bits
1bit
Even
1 byte
0
1
None
None