Mitsubishi Electric GOT2000 Series Connection Manual page 89

Address
Interrupt output
When data are written to D13 and D14 from a GOT touch switch, for example, the data of D13 and D14
are transmitted (interrupt output) to the host side.
The data amount (number of bytes) to be interrupt-output is set at "Interrupt Data Byte" in
"Communication Detail Settings".
➠
2.6.1 Setting communication interface (Controller Setting)
D13
• Output value when 1 is set to "Interrupt Data Byte" in "Communication Detail Settings"
Lower 8 bits
• Output value when 2 is set to "Interrupt Data Byte" in "Communication Detail Settings"
Upper 8 bits
• Output value when 4 is set to "Interrupt Data Byte" in "Communication Detail Settings
"(1) When setting the LH order to [32bit Storage] for the communication detail settings
D14
Upper 8 bits
(2) When setting the HL order to [32bit Storage] for the communication detail settings
Upper 8 bits
D15 to 19
D20 to 2031
D2032 to 2034
1-second binary counter
The counter is incremented at 1-second intervals after the GOT is turned ON.
D2035
(The time elapsed after GOT is turned ON is stored in 1-second units.)
Data are stored in binary format.
D2036 to 4095
*2 After writing data, the interrupt data is output within a period of 1 to 10ms.
*3 When data are written to D13 and D14 from the host side, interrupt output is not performed.
D13
1 byte
D13
Lower 8 bits
2 bytes
D14
Lower 8 bits Upper 8 bits
4 bytes
D13
Lower 8 bits Upper 8 bits
4 bytes
Description
*2*3
D13
Lower 8 bits
D14
Lower 8 bits
Unused
User area
Unused
User area
2.4 Device Data Area
Set side
2
User
―
User
―
System
User
2 - 19