3.5.2
Communication detail settings
Make the settings according to the usage environment.
Item
GOT NET No.
GOT Station
GOT Communication Port No.
Startup Time
Delay Time
32bit Storage
*1
Protocol
*2
Format
Interrupt Data Length
Special Interrupt Output
*3
Living Confirmation
*4
Living Confirmation Cycle
*1
*2
*3
*4
3 - 70
3.5 GOT Side Settings
Set the network No. of the GOT.
(Default: 1)
Set the station No. of the GOT.
(Default: 1)
Set the GOT port No. for the connection with the Ethernet module.
(Default: 5021)
Specify the time period from the GOT startup until GOT starts the
communication with the PLC CPU.
(Default: 3sec)
Set the delay time for reducing the load of the network/destination
PLC.
(Default: 0ms)
Select the steps to store two words (32-bit data).
(Default: LH Order)
Select the communication protocol
(Default: UDP/IP)
Select the communication format.
(Default: 1)
Specify the number of bytes of interrupt data.
(Default: 1)
Set whether or not to output the special interrupt code.
(Default: none)
Set whether or not to perform a living confirmation.
(Default: No)
Set the sampling to perform a living confirmation.
(Default: 20s)
For the interrupt output, select [TCP/IP].
For GT21, refer to the following.
Format: 5 to 9
Default: 6
Select [Yes] only when [Protocol] is [TCP/IP].
The setting value can be changed when the [Living Confirmation] is [Yes].
Description
*2
Range
1 to 239
1 to 64
1024 to 5010.
5014 to 65534
(Except for 5011, 5012, 5013
and 49153 to 49170)
3 to 255sec
0 to 10000
(
10ms)
LH Order/
HL Order
TCP/IP
UDP/IP
1 to 9
1 / 2 / 4
Yes or No
Yes/No
10 to 100s