Mitsubishi Electric GOT2000 Series Connection Manual page 437

*1 For applicable RFID controller of the type/number, configuration equipment, and for connection cables, refer to the following
Technical News.
➠
List of valid devices applicable for GOT2000 series (GOT-A-0064)
*2 When a GT10-C02H-6PT9P unit of the sub version A or B is used, do not ground the case of the D-sub (9-pin) connector.
*3 GT25-W does not support the option device.
POINT POINT POINT
When using the RS-232 communication unit
Use the RS-232 communication unit of the GOT for connecting to an RFID controller.
However, when the RS-232 communication unit is used, the following operations cannot be
supported.
(1) Using the external authentication
(2) Supplying the power to an RFID controller from the GOT
POINT POINT POINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
➠
Mitsubishi Products
➠
Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
➠ Microcomputer, MODBUS Products, Peripherals
21.2 System Configuration
21
21 - 3