■2. RFID setting
Step 1.
Select [Common]
Step 2.
Set the interface to which the RFID controller is connected.
Step 3.
Check the [Use RFID] to set the function. For details on the function setting, refer to the following manual.
➠
GT Designer3 (GOT2000) Screen Design Manual
Step 4.
Clicking the detail setting button displays the Communication Detail Settings dialog box for each
communication driver.Make the settings according to the usage environment.
➠
21.3.2 Communication detail settings
Click the [OK] button when settings are completed.
2.
3.
[Peripheral Setting]
POINT
POINT
POINT
(1) Communication interface setting
When Channel No.8 is used, the following external devices, which use Channel No.8, cannot
be connected at the same time.
• Barcode reader that requires the power supply
When connecting the above-mentioned devices at the same time, set [RFID] to Channels
No. 5 to 7.
(2) Setting for the driver
To Channels No. 5 to 8, multiple [RFID] cannot be set.
4.
Click!
[RFID] from the menu.
21.3 GOT Side Settings
21
21 - 5