4.9 Paper Exit
4.9.1 Exit Roll Assembly
Removal
1 Remove the Top Cover Assembly ( REP 4.2.6 Top Cover Assembly ).
2 Remove the Option Cover (REP 4.9.6 Option Cover/Eliminator Assembly).
3 Remove the three screws securing the Eliminator Assembly and take off the Exit Assembly.
4 Turn the Top Cover Assembly over.
5 Disconnect P/J24 (Exit Motor) and P/J124 (Rear Cover Sensor).
6 Remove the four screws securing the Exit Roll Assembly to the back side of the Top Cover
Assembly, and remove the Exit Roll Assembly from the Top Cover Assembly.
7 Pry off the hook of the bearings from the top face side of the Top Cover Assembly, and remove
the Exit Roll Assembly together with the two bearings.
8 Disengage the latch of the Gear and slide off the Gear and the two bearings together. (See
Figure 4.9.1.1.)
Replacement
Perform the removal steps in reverse order.
687200Q
Figure 4.9.1.1 Exit Roll Assembly Removal
SAS448F.CDR
Service Manual
SAS448F
4-43