Error Code "0001 - Olivetti DR N17 Service Manual

7.3.17.3 Error Code "0001"

You were directed to this RAP because the Control Panel displayed the error code "0001" during the
Power On Diagnostics.
1 Switch OFF the printer power.
2 Reseat the System Controller and then switch on the printer power.
3 The control panel displays "READY".
Y: Go to Final Actions.
N: Observe the Diagnostic LED at power on.
NOTE: If the LED flashes, refer to Table 7.3.17.1.1 Diagnostic LED Flash Sequence Table If the LED
does not glow or glows continuously, perform RAP 7.3.17.1 Power On Diagnostics (POD)
Failure.
7-36 687200Q