Olivetti DR N17 Service Manual page 496

9. Move the bottom portion of the Feed Roll Assembly-2 about 6 cm toward you while holding the Roll
Assembly in the state of step 8, then remove the whole assembly downward (See (9) in Figure
11.3.9.1).t out
10. Remove the upper Feeder Bearing from the Bearing Hole in the Main Chassis (See (10) in Figure
11.3.9.1).
4
SAS4CEFB
Replacement
Perform the removal steps in reverse order.
NOTE: Install the Feed Belt with the mark facing up. (A in the Figure 11.3.9.2). If installed with the mark
down, misfeeds can occur.
Also, Never install the Feed Belt inside out.
11-20
5
Figure 11.3.9.2 Feed Belt Removal
B
A
SAS4CEFB
FRONT
687200Q