Bottom Chute - Olivetti DR N17 Service Manual

4.6.10 Bottom Chute

Removal
1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
2 Remove the Registration Sensor ( REP 4.6.3 Registration Sensor ).
3 Remove the Front Tray Chute Assembly ( REP 4.6.4 Front Tray Chute Assembly ).
4 Pull out the wire harness from the junction connector (P/J 128) of the Toner Sensor.
5 Remove the screw securing the Bottom Chute on the right.
6 Remove the screw securing the right supporter to the Bottom Chute.
7 Remove the Bottom Chute from the Paper Handling Unit Assembly.
Replacement
Perform the removal steps in reverse order.
687200Q
Figure 4.6.10.1 Bottom Chute Removal
SAS428F.CDR
Service Manual
SAS428F
4-33