4.2.6
Top Cover Assembly
Removal
1 Open the Front Cover Assembly.
2 Remove the Left Cover ( REP 4.2.2 Left Cover ).
3 Remove the Left Front Cover ( REP 4.2.5 Left Front Cover ).
4 Remove the System Controller Chassis ( REP 4.12.1 System Controller Chassis ).
5 Disconnect the four connectors (P/Js 23, 24, 28, and 32) from the Print Engine Controller. (See
Figure 4.2.6.1.)
6 Remove the four screws securing the Top Cover.
NOTE: You must open the Rear Cover to remove two of the four screws.
7 Remove the Wire Harness from the Wire Holder.
8 Lift upward and remove the Top Cover Assembly.
Replacement
Perform the removal steps in reverse order.
4-12
Figure 4.2.6.1 Top Cover Assembly Removal
wsm4-11
sas406fa
687200Q